Helping The others Realize The Advantages Of accurate no 2 load data

Helping The others Realize The Advantages Of accurate no 2 load data

Blog Article

He explained starting loads for 2400 really should be Risk-free with 410 but to look at pressures very carefully as maximums had been approached and temps fall. I locate it Peculiar that Alliant expresses a difficulty then suggests the way to carry on with applying it! I'm wondering just how much 'disclaimer' is in the response?



I feel they shot one ball load even though but in any case could be fun to shoot and is too lousy They are really singleshots and wont have a Magazine.

Only problem with not reaming the shot bushing to toss 226 of shot in the HS hull with .296" powder bushing, would be the shot will probably rattle inside the shell (my Model of the practice only load Should the shot rattles when you shake the spherical).

so begin a grain or two lessen and get the job done up Except if you'll be able to confirm that has a scale that a 5 pellet load of The actual OOO pellets you happen to be using will not exceed three/four-oz.

Rem. and Gain. hulls are interchangable with loading data as These are both tapered hulls, but wad height is a bit higher within the Rem Wad which makes for a better accurate gunpowder crimp

This can be an more mature thread, you might not receive a response, and could be reviving an aged thread. You should take into account creating a new thread.




So 296/297 at 1200fps leaves a great deal of unburnt powder inside the bore, when the speedier/higher Functioning pressure loads genuine finally ends up with much less unburnt powder in the bores isntead.

“I hate how just after an argument I think about much more intelligent items I ought to have mentioned.” – Mirtunjay Upadhyay

Accurate 1680 uses the best ballistic professionals as well as the highest high quality components together to assure that every gun is best served with Accurate Powders.

The information exhibited on This website, which include ballistic data, was derived from tightly managed laboratory circumstances.

So the moment I figured this out, I seperated all of the shells from smallest to tallest. I load the small ones perfectly. I take advantage of Alliant Green Dot powder with very little to no troubles. So now I will do the newbie factor and hyjack this thread using a similar dilemma for anyone with assistance or respond to.

Made by showin




Secondly, the perspective that Lil Gun kills hull life. I get multiple reloads with Lil Gun in AAHS hulls. I also like 296/H110 - important site but just saying, Lil Gun is an efficient powder as well. And it patterns perfectly in my gun - together with any .410 powder.

The shell are definetly below powered. Again I am employing Alliant Green Dot powder as proposed from other discussion boards that I go through. I am open to any strategies or advice on these loads.